Hoe To Put Wheel Back In Track On Garage Door

Use a rubber mallet to tap the edge of the roller back into the track.

Hoe to put wheel back in track on garage door.

Open the door while holding the roller against the track. Get a helper to lift the door. Unaligned tracks are caused by screws that loosen over time. The roller has a stem that fits into a bracket sleeve while the roller itself fits into a track.

The point where the roller is nearest the track is probably the point where it jumped the track. Once you locate where the wheels on the door are jumping off the track snap locking pliers underneath the door on one of the tracks. This can be an easy fix and requires no tools. This causes the track to shift at an angle that is not at a right angle to the door of your garage.

Use a rubber mallet to tap the track into the correct position once the door is once again aligned on the track properly. This will make it simple to position the wheel back onto the track. Dislodge the hand held vise grips. However it s not guaranteed that the roller will stay there no matter what.

The pliers act as a stop. The doors on your garage are moved smoothly up and down by garage door rollers these are held in place by brackets that are attached to the door of your garage. Work a flat head screwdriver under one of the wheels lift it and angle the door slightly until the wheel clears the track. To determine if it is in perfect alignment use the level.

Top roller is the ea. Repeat with the other wheel then angle the bottom of the door out and remove the door. Open the door manually. Use pliers to open the outer edge of the track.